 |
mith & Wesson Victory Adapter Only
Smith & Wesson Victory MAGAZINES.
(Downloadable PDF)
|
Hold the loader in your left hand, and press the adapter lock with your thumb. With your right hand, hook the Mag Adapter into the top of the Lightnin' Grip Loader and swing the bottom into the slot. Take your thumb off of the lock button. it should pop out to the locked position when the adapter is in fully seated.
|
|
|
Insert your magazine through the small ring into the adapter until it latches into notch. The follower of your magazine will be pushed down when this is done
|
|
|
Be sure to have 10 shells lined up before loading and hold loader vertical.
To remove the magazine, while holding like pictured on right, gently press down on latch and pull out.
|
 
|
LIGHTNIN' GRIP LOADER INSTRUCTIONS
|
1.) Slide open the Bullet Reservoir Cover and drop in up to (50) 22LR cartridges.
2.) Close cover. Gently shake the Lightnin' Grip Loader, keeping it level and
the reservoir cover on top.
3.) Raise the reservoir end to slide the cartridges in to the Loading Channel.
4.) Repeat #2 and #3 until the Loading Channel fills sufficiently.
|
FILL WITH AMMO
|
|
5.) Raise the reservoir end and smoothly squeeze the trigger to load a round
into the magazine. The trigger needs to return to the nearly out position to
seat the round and stage another bullet for loading. It is usually a good idea
to count the bullets going in to know when to stop. It is possible to force in an
extra round.
NOTE: Quickly snapping the trigger in can cause the bullets to bounce in some
magazines and "hook" the rims in the wrong direction making them hard to get out.
Sometimes a hard rap on the bottom of the magazine with your palm or on a book
will bounce the bullets to unhook them.
|
ALIGN BULLETS
|
TIPS:
Some 22LR cartridges are real sticky with wax lube. After filling the reservoir, give
them a shot of Remington (Rem Oil) Teflon Spray Lube. Only a small amount is
needed.
CAUTION: the unit is molded from Lexan, and some lubes will attach it.
Not all magazines fit the same; you may need to apply a little seating pressure
against the magazine as you are loading it. As Pictured here.
Periodically take a look at our website for updated tips.
|
HOLD MAG SEATED AND SQUEEZE TRIGGER.
|
|
|
|
Works Great! 
Good but... 
